Service And Maintenance; Vehicle Identification Plate Location - Hammerhead Charger 48V Operator's Manual

SERVICE AND MAINTENANCE
To reduce the possibility of severe injury or death from improper servicing
techniques:
Do not attempt any type of servicing operating before reading and understanding
all notes, cautions and warnings in this manual. Any servicing requiring
adjustments to be made on the motor while the motor is running must be made
with both drive wheels raised and vehicle properly supported on stands. To
reduce the possibility of motor damage, never operate vehicle at full throttle for
more than 4‐5 seconds while vehicle is in a 'no load' condition.
To reduce the possibility of causing an electrical arc, which could result in a battery
explosion, turn off all electrical loads from the battery before removing battery
wires.
The electrolyte in a battery is an acid solution which can cause severe burns to the
skin and eyes. Treat all electrolyte spills to the body and eyes with extended
flushing with clear water. Contact a physician immediately.
Any electrolyte spills should be neutralized with a solution of 2 teaspoons (10ml) of
sodium bicarbonate (baking soda) dissolved in 1 quart (1 liters) of water and
flushed with water.
It is in the best interest of vehicle owner to keep up with preventative maintenance
schedule for keeping the vehicle both dependable and economical. This vehicle will
give years of satisfactory service, providing it receives regular maintenance schedule
listed below.
V I
EHICLE DENTIFICATION
The vehicle Identification plate is on the vehicle behind the driver's seat. (See
image below). Design changes take place on an ongoing basis. In order to obtain
the correct components for the vehicle, the VIN number must be provided when
ordering service parts.
Hammerhead Charger Electric Vehicle Operator's Manual
P L
LATE OCATION
Page 22