Direction Selector - Hammerhead Charger 48V Operator's Manual

DIRECTION SELECTOR
Located on the control panel, this switch permits the select of either "FWD" for
forward moving, "REV" for reverse, or Neutral (the position between forward and
reverse). Vehicle should be left in neutral when unattended. (See Image Below)
To reduce the possibility of component damage, the vehicle must be completely
stopped before moving the direction selector.
STATE OF CHARGING
Located in the dash, the state of charging meter indicates the amount of usable
power remaining in the batteries. (See image below)
COMBINATION LEVER
Much like a car's turning signal lever, this combination lever is located below the
steering wheel on the steering column operates turning signals, high/low beam lights
and horn. Push down on the combination lever to signal turning left, push up the
lever to signal turning right. Push in on the lever to turn on high beam, pull back on
the lever to turn on the high beam. Push in on the end of the lever to horn. (See
image below)
Hammerhead Charger Electric Vehicle Operator's Manual
METER
(T S
URNING IGNALS
, H B L
IGH EAM IGHTS
, H )
ORN
Page 11