Table of Contents
Advertisement
Overheat/Fan Fail LED (OH)
Connect an LED to pins 7 and 8 of
JF1 to provide advanced warning of
chassis overheating or fan failure.
Refer to the table on the right for pin
defi nitions.
NIC1 (GLAN) LED
The LED connections for the GB LAN
port are on pins 11 and 12 of JF1. At-
tach an LED cable to display network
activity. See the table on the right for
pin defi nitions.
HDD LED
The HDD LED connection is located
on pins 13 and 14 of JF1. This LED
is used to display all IDE and SATA
activity. See the table on the right for
pin defi nitions.
Power On LED
The Power On LED connector is lo-
cated on pins 15 and 16 of JF1 (use
JLED for a 3-pin connector). This
connection is used to provide LED
indication of power being supplied to
the system. See the table on the right
for pin defi nitions.
Chassis Intrusion
The Chassis Intrusion header is des-
ignated JL1. Attach an appropriate
cable from the chassis to inform you
of a chassis intrusion when the chas-
sis is opened
Chapter 5: Advanced Serverboard Setup
OH/Fan Fail LED
Pin Defi nitions (JF1)
Pin#
Defi nition
7
Vcc
8
Ground
Pin Defi nitions (JF1)
Pin#
11
12
Pin Defi nitions (JF1)
Pin#
13
14
Pin Defi nitions (JF1)
Pin#
15
16
Chassis Intrusion
Pin Defi nitions (JL1)
Pin#
1
2
5-15
OH/Fan Fail Indicator
Status
State
Defi nition
Off
Normal
On
Overheat
Flash-
Fan Fail
ing
NIC1 LED
Defi nition
Vcc
Ground
HDD LED
Defi nition
Vcc
HD Active
Power LED
Defi nition
5V Stby
Control
Defi nition
Intrusion Input
Ground
Advertisement
Table of Contents
