Table of Contents
Advertisement
Hardware Installation
1.
Turn Off the power to your computer and any other connected
peripheral devices.
2.
Unplug the power cord form the back of the computer.
3.
Remove your computer's cover.
4.
Remove the slot bracket from an available PCI slot.
5.
To install the card, carefully align the card's bus connector with
the selected PCI slot on the motherboard. Push the board down
firmly, but gently, until it is well seated.
6.
Replace the slot bracket's holding screw to secure the card.
Device Connection
The SATA 150 4-Channel PCI RAID Card is a four channel Serial ATA
controller that supports up to four Serial ATA hard disk drives. It is
recommended to use identical hard drives for all RAID configurations.
1.
Install your hard disk drive(s) in chassis.
2.
Connect the Serial ATA hard disk drive to the system power
supply using the included Serial ATA power cable.
3. Connect one end of the Serial ATA cable to the hard disk drive.
4. Attach the other end of the Serial ATA cable to the Serial ATA
controller on the SATA 150 4-Channel PCI RAID Card.
5. Follow the same instructions to connect up to four hard drives.
Device connection is now complete.
6. Replace the computer cover and reconnect the power cord.
3
Advertisement
Table of Contents
