Download
Share
Print this page
Digitus DS-33002-1 User Manual
  1. Manuals
  2. Brands
  3. Digitus Manuals
  4. PCI Card
  5. DS-33002-1
  6. User manual

Digitus DS-33002-1 User Manual

Universal pci rs-232 board
Hide thumbs
1
2
3
4
5
6
7

Advertisement

Quick Links

Download this manual
UNIVERSAL PCI RS-232 BOARD
User Manual
DS-33002-1

Advertisement

loading

Related Manuals for Digitus DS-33002-1

Summary of Contents for Digitus DS-33002-1

  • Page 1 UNIVERSAL PCI RS-232 BOARD User Manual DS-33002-1...

  • Page 2: System Requirements

    Features  Expands Multi RS-232 serial ports on the system  High performance SUNIX 16C950 compatible UART controller on-board.  Ultra low power consumption design for Green Environment.  Compliance with PCI 33MHz Version 3.0/2.3/2.2/2.1 specification.  Supports both 64-bit PCI-X & 32-bit PCI bus slot. ...

  • Page 3: Driver Installation

    If fitted. Remove the metal cover plate on the rear of a free PCI slot. Insert Universal PCI Multi-Port Communication Board into the free PCI slot and screw it firmly on the bracket side. Place the cover back onto the computer. Insert the plug into the plug socket.
  • Page 4 # cd/temp/snx # make clean; make install ************************************************************* * If system is Suse 9.0 and errors occur when * “make clean; make install”, do commands: * # cd/usr/src/linux/ * # make cloneconfig * # make dep * then do “make clean; make install” again in/temp/snx ************************************************************* Load driver module, do command: # modprobe snx...

  • Page 5: To Verify Driver Installation

    To Verify Driver Installation Click on the “Device Manager” tab in System Properties, which you access from the Windows Control Panel. You should see a “4-Port Serial Card” under the “Multifunction adapters” item and “COM Port (COMx)” under the “Ports (COM & LPT)” Port Configuration 1.
  • Page 6 3. COM I/O Resource  User can read the COM “IO Range” and “IRQ” located in system by selecting COM port.  IRQ and I/O address is automatically assigned by the mainboard PCI BIOS automatically (before COM card driver installing). User can NOT assign legacy ISA address (3F8, 3E8, 2F8, 2E8) for the specific COM port.
  • Page 7  Transmit FIFO interrupt trigger level: When the level of data in the transmit FIFO falls below this value, a transmitter interrupt is triggered. Setting this value to zero will not trigger an interrupt until the transmitter is completely idle. ...