Selecting A Font; Selecting The Quiet Print Mode; Changing The Auto Load Position - Star LC-7211 User Manual

20 Control Panel Operations

Selecting a font

Make sure the printer is off-line (ON LINE indicator is not lit).
Press FONT to change the font selection. An indicator lights to the left of
the name of the font that is currently selected.
Lit Indicator
ROMAN
ROMAN + COURIER
COURIER
COURIER + ORATOR
ORATOR

Selecting the Quiet Print Mode

The Quiet Print Mode lets you print with less noise than that produced with
normal printing. Use the following procedure to enter and exit the Quiet Print
Mode.
Important!
Though the Quiet Print Mode prints more quietly, it also causes printing to
take considerably longer than normal printing.
Make sure the printer is on-line (ON LINE indicator is lit).
Press FONT, to toggle between the Quiet Print Mode and normal printing.
The QUIET indicator is lit when the Quiet Print Mode is selected, and is not
lit when normal printing is selected.

Changing the auto load position

Normally the printer automatically feeds paper to a standard position (1/6-inch
from the top of the paper). This is called the auto load position. You can use the
following procedure to specify a different auto load position.
Make sure the printer is off-line (ON LINE indicator is not lit).
While holding down ON LINE, press FONT and then release the two
buttons.
The printer will automatically eject the cut-sheet that is in the printer, or
reverse feed fanfold paper until it is no longer in contact with the platen.
Also, all the font and pitch indicators on the control panel will light.
Font Name
Roman
Sanserif
Courier
Prestige
Orator