Parts, Tools, And Materials - Amana MVH140E Service Manual

Installation Instruction

Parts, Tools, and Materials

The following parts are supplied with the oven:
NOTE: Depending on ventilation requirements, not all parts will be used.
Backdraft damper / duct connector
(for roof-venting or wall-venting installation)
Not Actual Size ( 2 pieces must be
assembled as shown )
Two self - tapping screws
(for attaching the damper duct connector)
Four 1/4" x 2" lag screws -
(for wall stud holes)
Two 1/4" x 2" bolts -
(for securing to the upper cabinet)
Two washers -
(for the two upper cabinet bolts)
NOTE: Install at two lag screws into one 2" X 4" stud and four anchor bolts into the wall.
The mounting area must meet the 150 lbs. weight requirement.
Tools and materials required for installation:
NOTE: Use the carton or heavy material for covering the counter top.
NOTE: Ductwork required for installation is not included. All wall and roof caps must have a back-draft damper.
One power cord clamp and
One dark-colored mounting screw
(to hold the power cord)
Actual Size
One power cord clamp bushing -
(for the cord hole in a metal upper cabinet)
9
One lock pin and one washer-
Four 1/4" x 3" toggle bolts -
(for drywall holes)
Four spring toggle heads -
(for the toggle bolts)
RS21000005 Rev. 0