Subscribe to Our Youtube Channel
Related Manuals for Amana MWT4461D
Summary of Contents for Amana MWT4461D
-
Page 1: Installation Instructions
Over the Range Microwave Oven Installation Instructions MWT4461D MWT4461WW MVH120E MVH220E MVH220W MVH320E MVH320L MVH320W Read all instructions before starting installation. Important--Save these instructions for electrical inspector's use. -
Page 2: Installation Requirements
Installation Requirements Mounting Space Important Safety Instructions This over-the-range microwave oven requires wall Recognize this symbol as a SAFETY mounting space, as shown below. • Minimum of 30 inches between cabinets is required for message installation. If space between cabinets is greater Caution than 30 inches, filler panel kit may be used to fill in gap between microwave oven and cabinets. -
Page 3: Hood Exhaust Duct
Materials Needed (Not Supplied) Hood Exhaust Duct Outside ventilation requires hood exhaust duct. Use only • Phillips screwdriver metal duct. Read the following carefully. • Pencil • Ruler or tape measure and straight edge Exhaust Connection: Hood exhaust has been designed •... - Page 4 Installation Instructions A. Removing Mounting Plate Outside Top Exhaust (Vertical Duct) 1. Place protective blanket on work surface to Slide exhaust adaptor to one side, squeeze sides and protect outer case of microwave oven. Place remove. Save damper and exhaust adaptor. microwave oven on control panel side.
- Page 5 Carefully pull out blower unit. Wires extend far Fit exhaust adaptor into house duct. Be sure damper enough to allow for blower adjustments. hinge is on top and damper swings free into wall Turn blower unit end-over-end. Roll blower unit so outlet.
- Page 6 Replace blower plate using 5 screws. Carefully pull out blower unit. Wires extend far enough to allow blower adjustments. Roll blower unit so blades face towards front of microwave oven. Wires should be routed in front of motor frame. Remove 2 screws on front of grille. Remove grille. 10.
-
Page 7: Outside Back Exhaust
1. Find studs, using one of following methods: Drill holes through circles. Diameter of holes should be 5/8 inch for toggle bolts and 3/16 inch for wood • Stud finder--magnetic device which locates nails. screws on studs. Use at least 1 wood screw in stud, •... -
Page 8: Installation Checklist
F. Mounting Microwave Oven Use rectangular washer to mark hole for drilling in left side rectangular slot. Place washer in slot by Locate grease filters packed separately and set aside. grasping "ears" on washer to center in opening. Mark Thread power cord through hole, or slot, in bottom of location of hole on rear wall with pencil. - Page 12 © 1994 Amana Refrigeration, Inc. Part No. C8935506 ® Amana, Iowa 52204 Printed in U.S.A.
Need help?
Do you have a question about the MWT4461D and is the answer not in the manual?
Questions and answers