Humidity Sensor; Oven Thermostat; Base Thermostat; Light Socket - Amana MVH140E Service Manual

Disassembly Procedures
!

Humidity Sensor

The sensor is a plug-in device located in the air exhaust
duct.
Humidity Sensor Removal
1. Disconnect power to oven and remove control panel,
(see "Control Panel" section).
2. Discharge high voltage capacitor, (see "High Voltage
Capacitor" section).
3. Remove outer case, (see "Outer Case" section).
4. Remove screws securing sensor to air duct.
5. Disconnect wire terminal plug and replace with new
sensor.
6. Reassemble in reverse order.

Oven Thermostat

The oven thermostat is located under the air duct
assembly.
Thermostat is a resettable thermostat.
1. Disconnect power to oven and remove control panel,
(see "Control Panel" section).
2. Discharge high voltage capacitor, (see "High Voltage
Capacitor" section).
3. Remove outer case, (see "Outer Case" section).
4. Remove screws securing air duct to oven cavity.
5. Disconnect wires from oven thermostat and replace
thermostat.
6. Reassemble in reverse order.
WARNING
To avoid the risk of electrical shock, personal injury, or
death, disconnect power to oven and discharge
capacitors before following any disassembly procedure.

Base Thermostat

The base thermostat is located behind the control panel
assembly.
Thermostat is a resettable thermostat.
1. Disconnect power to oven and remove control panel,
(see "Control Panel" section).
2. Discharge high voltage capacitor, (see "High Voltage
Capacitor" section).
3. Remove screws securing thermostat to base plate
and disconnect wires from thermostat.
4. Reassemble in reverse order.

Light Socket

1. Disconnect power to oven and remove grille, (see
"Grille" section).
2. Remove screws securing bulb holder.
3. Remove light bulb. Remove light socket.
4. Disconnect wire terminal plug.
5. Replace and reassemble in reverse order.
37 RS2100005 Rev. 0