Table of Contents
Advertisement
Quick Links
®
Over-the-Range
Microwave Oven
Installation
Instructions
MVH130*
MVH230*
MVH330*
* Additional alphanumeric characters representing other
models in the series may follow each model number.
Keep these instructions for future reference. If the oven
changes ownership, be sure this manual accompanies
oven.
Advertisement
Table of Contents
Related Manuals for Amana MVH130 SERIES
Summary of Contents for Amana MVH130 SERIES
- Page 1 ® Over-the-Range Microwave Oven Installation Instructions MVH130* MVH230* MVH330* * Additional alphanumeric characters representing other models in the series may follow each model number. Keep these instructions for future reference. If the oven changes ownership, be sure this manual accompanies...
-
Page 2: Installation Requirements
Installation Requirements Mounting Space Important Safety Instructions This over-the-range microwave oven requires wall Recognize this symbol as a SAFETY mounting space, as shown below. • Minimum of 30 inches between cabinets is required for message installation. If space between cabinets is greater Danger than 30 inches, filler panel kit may be used to fill in gap between microwave oven and cabinets. -
Page 3: Hood Exhaust Duct
Hood Exhaust Duct Materials Needed (Not Supplied) Outside ventilation requires hood exhaust duct. Use only • Phillips screwdriver metal duct. Read the following carefully. • Pencil • Ruler or tape measure and straight edge Exhaust Connection: Hood exhaust has been designed •... -
Page 4: Installation Instructions
Installation Instructions A. Removing Mounting Plate Outside Top Exhaust (Vertical Duct) 1. Place protective blanket on work surface to Slide exhaust adaptor to one side, squeeze sides and protect outer case of microwave oven. Place remove. Save damper and exhaust adaptor. microwave oven on control panel side. - Page 5 Carefully pull out blower unit. Wires extend far Fit exhaust adaptor into house duct. Be sure damper enough to allow for blower adjustments. hinge is on top and damper swings free into wall Turn blower unit end-over-end. Roll blower unit so outlet.
- Page 6 Carefully pull out blower unit. Wires extend far Replace blower plate using 5 screws. enough to allow blower adjustments. Roll blower unit so blades face towards front of microwave oven. Wires should be routed in front of motor frame. Remove 2 screws on front of grille. Remove grille. 10.
-
Page 7: Outside Back Exhaust
1. Find studs, using one of following methods: Drill holes through circles. Diameter of holes should • Stud finder--magnetic device which locates nails. be 5/8 inch for toggle bolts and 3/16 inch for wood screws on studs. Use at least 1 wood screw in stud, •... -
Page 8: Installation Checklist
Install grease filters. F. Mounting Microwave Oven For top exhaust, open top cabinet and attach exhaust adaptor to microwave oven through cabinet bottom. For front-to-back or side-to-side adjustment, slide Caution exhaust adaptor as needed. To avoid personal injury and oven door damage, do not lift oven using door handle. - Page 12 © 1996 Raytheon Appliances Part No. C8935507 Printed in U.S.A. Amana, Iowa 52204...
Need help?
Do you have a question about the MVH130 SERIES and is the answer not in the manual?
Questions and answers