Turntable Motor; Vent Blower; Probe Receptacle - Amana MVH140E Service Manual

Disassembly Procedures
!

Turntable Motor

1. Disconnect power to oven.
2. Remove screws securing bottom plate cover.
3. Open the oven door, remove turntable, and gently pry
upward on turntable shaft.
4. Disconnect wire leads from turntable motor.
5. Remove screws securing turntable to the oven cavity.
6. Replace and reassemble in reverse order.
RS2100005 Rev. 0
WARNING
Wire leads
Turntable motor
To avoid the risk of electrical shock, personal injury, or
death, disconnect power to oven and discharge
capacitors before following any disassembly procedure.

Vent Blower

Vent blower is a two speed (HI-LOW) capacitor run
blower assembly located on top of the oven. The blower
is operated by voltage relays located on the p.c. board.
Vent Exhaust Blower Removal
1. Disconnect power to unit.
2. Remove unit from its installation.
3. Remove screws securing damper and motor
assembly to top and back of unit.
4. Remove damper.
5. Lift blower assembly out and disconnect wire
connection wire terminal.
6. Reassemble in reverse order.
NOTE: Place blower assembly wires in slotted area to
avoid pinching of wires.
38
Vent plate