Stirrer Assembly; Stirrer Motor (Mvh240 And Mvh340) - Amana MVH140E Service Manual

Disassembly Procedures
!

Stirrer Assembly

Motor driven antenna assembly is located at the top of
the cavity, using a top feed wave guide.
Stirrer Blade Removal
1. Disconnect power to oven and open the oven door.
2. Carefully pry downward on the plastic rivets securing
the stirrer cover.
3. Reassemble in reverse order.
Stirrer assembly for MVH140*
Stirrer assembly for MVH240* and MVH340*
WARNING
To avoid the risk of electrical shock, personal injury, or
death, disconnect power to oven and discharge
capacitors before following any disassembly procedure.

Stirrer Motor (MVH240 and MVH340)

1. Disconnect power to oven and remove control panel,
(see "Control Panel" section).
2. Discharge high voltage capacitor, (see "High Voltage
Capacitor" section).
3. Remove outer case, (see "Outer Case" section).
4. Remove screws securing air duct to oven cavity and
two screws securing stirrer motor.
5. Lift air duct and disconnect wires from stirrer motor.
6. Remove and replace stirrer motor in reverse order.
33 RS2100005 Rev. 0