Table of Contents
Advertisement
Disassembly
!
Top Antennas
1. Remove outer case.
2. Remove grease shield.
3. While holding antenna, remove wire securing
antenna to gear at top of unit.
4. Remove antenna.
5. Remove gear.
Arrow
Dot
NOTE: Gears are aligned by aligning the arrows to the
dots.
Cotter
Pin
Antenna
Motor
NOTE: Nylon washers must be installed below gears.
Top Antenna Motor
1. Remove outer case.
2. Remove three antenna gears.
3. Disconnect motor wiring.
4. Remove three stirrer motor bracket mounting rivets.
The motor and bracket are replaced as one part.
NOTE: Gears are aligned by aligning the arrows to the
dots on gears.
RS2220001 Rev. 2
WARNING
Arrow
Dot
Antenna
Gear
Nylon
Washer
Rivet
Antenna
To avoid the risk of electrical shock, personal injury, or
death, disconnect power to oven and discharge
capacitors before following any disassembly procedure.
Antenna Matching
Antenna
Motor
Early Production
Antenna
Motor
Standard
Antenna
Later Production
!
When servicing the top antennas, give careful
attention to the color of the antenna tip. Part #
10787601 is standard non-colored. Part # 10787602 is
blue-tipped. These antennas are not
interchangable. Refer to Parts Manual for correct
application.
32
Standard
Antenna
Blue-Tipped
Antenna
WARNING
Rivet
Rivet
Hide quick links:
Advertisement
Table of Contents
