Blower Motor Or Wheel; Splatter Shield; Antenna; Stirrer Motor - Amana RCS10DA Service Manual

Disassembly Procedures
!
WARNING

Blower Motor or Wheel

1. Disconnect power to oven and remove outer case,
(see "Outer Case" procedure).
2. Remove outer case.
3. Disconnect wiring from blower motor.
4. Remove screws securing scroll to chassis.
5. Slide scroll discharge snout from partition and lift
scroll assembly from unit.
6. Replace component and reverse procedure to
reassemble.
30
To avoid the risk of electrical shock, personal injury, or death,
disconnect power to oven and discharge the capacitors before
following any disassembly procedure.

Splatter Shield

NOTE: Be careful not to bend antenna when removing
splatter shield. Shield snaps into a lip in front of
the oven and three slots in the back.
1. Place your thumbs in the two indentations in front of
the shield.
2. Press lightly towards the back and carefully lower
shield away from antenna.
3. Pull shield out of the back slots and out of the oven.
Splatter
shield

Antenna

1. Remove splatter shield from oven cavity.
2. Remove two mounting rivets on the top of oven cavity
to remove cradle. Support cradle before removing
mounting rivets to avoid damage to antenna
assembly.

Stirrer Motor

1. Disconnect power to oven and remove outer case,
(see "Outer Case" procedure).
2. Remove outer case.
3. Disconnect wire terminal s from stirrer motor.
4. Remove screws securing stirrer motor to wave guide.
5. Replace component and and reverse procedure to
reassemble.
NOTE: When replacing stirrer motor, verify motor shaft is
aligned with antenna shaft before securing with
screws.
16023293 Rev. 0
©2004 Maytag Services