Programming Channels Into The Tv's Channel Memory - Toshiba 40VL20 Series Owner's Manual

Programming channels into the TV's channel
memory
• First, use the Auto Tuning function to preset all
the active channels in your area automatically.
Then, arrange the preset channels with the
Manual Tuning function so that you can tune into
only desired channels.
• Use the Manual Tuning operation if desired
channels cannot be preset with the Auto Tuning
or if you would like to preset channels to specifi c
position numbers one by one.
Auto Tuning
1
From the SETUP menu, press
Auto Tuning.
SETUP
Menu Language
Auto Tuning
Manual Tuning
Quick Setup
Location
Software Upgrade
Software Licences
System Information
2
Press Q to display the Auto Signal Booster
menu (- page 11), press
or No.
3
Press Q to display the Auto Tuning menu.
Auto Tuning
Previous settings will be lost! Press EXIT for no
change.
Start Scan
4
Press Q to start the automatic search.
The search will begin for all available stations.
Auto Tuning
Progress
1%
5
When the automatic search is completed, the
TV will automatically return to 1 position.
Manual Tuning
1
From the SETUP menu, press
Manual Tuning.
2
Press Q to display the Manual Tuning menu.
Press or to select the programme position
you want to arrange.
14
Introduction / Getting started
3
or to select
English
Antenna
Home
or to select Yes
Found
or to select
Manual Tuning
Pos. Channel
1 C-02
2 C-04
3 C-05
4 C-07
5 C-09
6 C-12
7 S-17
8 S-19
Press Q to display the breakdown menu.
Press or to select an item, then press
to select the item as shown below.
Manual Tuning
Position
1 B/G A C 2
A C E F G
B D
A. Position selection
B. System (Sound) (- page 56)
C. Colour System (- page 56)
A : Automatic (factory set), P : PAL,
S : SECAM, N4 : NTSC 4.43 (MHz),
N3 : NTSC 3.58 (MHz)
If the colour of a certain channel is
abnormal, the automatic colour system
selection (A) may have malfunctioned, or
sound system selection is wrong. In such a
case, select another colour and/or sound
system (- page 57).
D. Position skip selection
Press or to turn the position skip
option on "8" or off "(".
The position will then be skipped when you
select channels with PU or Pu.
The "8" mark will appear when you use the
Number button on the remote control.
E. Signal Class selection (- page 55)
Press or to select C or S.
C: 1 ch - 12 ch, 21 ch - 70 ch
S: 1 ch - 41 ch, 51 ch - 55 ch
F. Channel selection
Press or until your desired channel is
displayed (- page 55).
G. Search operation
Press to search up the band or
search down the band.
Press or repeatedly until your desired
signal is displayed.
NEVER PRESS ANY OTHER BUTTONS WHILE
THE SET IS TUNING.
Label
or
0 On
J
H I
to