Table of Contents
Advertisement
Changing the on-screen display language
You can choose from three different languages (English, French and
Spanish) for the on-screen display of adjustment menus and messages.
To select an on-screen display language:
1. Press MENU, and then press x or • until the SET UP menu
appears.
2. Press y or z to highlight LANGUAGE.
3. Press x or • to highlight your desired language.
SET UP
LANGUAGE:
[ENGLISH]
FRANCAIS ESPANOL
ANT 1/2:
[ANT1] ANT2
TV/CABLE:
[TV] CABLE
CH PROGRAM
ADD/ERASE:
[ADD] ERASE
MORE
SELECT [
]
MOVE
[
]
Programming channels into the channel
memory
When you press CHANNEL y or z on the remote control or
TV front panel, your TV will stop only on the channels stored in the
channel memory. Follow the steps below and on the next page to
program channels into the channel memory.
Programming channels automatically
Your TV can automatically detect all active channels in your area and
store them in the channel memory. After the channels are stored
automatically, you can manually add or erase individual channels. If
you use both ANT 1 and ANT 2 input sources, you must program
channels for each source separately.
To program channels automatically:
1. Press MENU, and then press x or • until the SET UP menu
appears.
2. Press y or z until ANT 1/2 is highlighted.
3. Press x or • to highlight either ANT 1 or ANT 2, depending on
which antenna input you are programming channels for.
SET UP
LANGUAGE:
[ENGLISH] FRANCAIS ESPANOL
ANT1/2:
[ANT1]
ANT2
TV/CABLE:
[TV] CABLE
CH PROGRAM
ADD/ERASE:
[ADD] ERASE
MORE
MOVE
[
]
SELECT [
]
4. Press y or z until TV/CABLE is highlighted.
5. Press x or • to highlight either TV (if you use an antenna) or
CABLE (if you have cable service).
SET UP
LANGUAGE:
[ENGLISH] FRANCAIS ESPANOL
ANT 1/2:
[ANT1] ANT2
TV/CABLE:
[TV]
CABLE
CH PROGRAM
ADD/ERASE:
[ADD] ERASE
MORE
[
]
SELECT [
]
MOVE
(Continued on next page)
MENU
yzx •
CHANNEL yz
23
Advertisement
Table of Contents
