Toshiba 40VL20 Series Owner's Manual page 41

Item
Status Connected is displayed when
the TV is connected with the AP.
Disconnected is displayed
when the TV is not connected
with the AP.
Signal Connection signal strength with
AP (STRONG/MEDIUM/WEAK)
Speed Link with AP
Mode Working mode (11a, 11b, 11g,
11n)
Network Name SSID set
Authentication Authentication set
Encryption Encryption set
Security Key Security Key set
AP MAC The AP's MAC address is
Address displayed when the TV is
connected with the AP.
TV MAC The MAC address of the USB
Address (Dual Band WLAN Adaptor) is
displayed.
DHCP Enabled is displayed when
using DHCP.
Disabled is displayed when not
using DHCP.
IP Address The TV's IP address
Subnet Mask Value of the Subnet Mask
Default Address of the Default GATEWAY
Gateway
DNS Address of the DNS
Note:
Even if an AP for IEEE 802.11n is used when
Encryption is set to WEP or TKIP, the Speed value
might below. It is recommended that Encryption be
changed to AES (see "Manual Setup" - page 40).
Notes on wireless LAN environment:
• The function of all IEEE 802.11 is not supported.
• The ad-hoc mode is not supported.
• It is recommended to use IEEE 802.11a or
IEEE 802.11n on 5 GHz for audio and SD video
streaming.
• It is recommended to use IEEE 802.11n on 5 GHz
for HD video streaming.
• It is recommended that the encoding rate for
streaming video content is 20 Mbps or less.
Connecting your TV
Description
• It is not recommended to use 2.4 GHz for audio
and video streaming.
• Content playback may be interrupted by various
surrounding interference.
Advanced Network Setup
Notes:
• When the DHCP function of the router connected
with this TV is On, you can set Auto Setup to On or
Off . (This should usually be set to On.)
• When the DHCP function of the router is Off , set
Auto Setup to Off , and set the IP Address manually.
IP Address Setup
Auto Setup:
1
From the PREFERENCES menu, select Network
Setup and press Q.
2
Press or to select Advanced Network
Setup, and press Q.
3
Press or to select IP Address Setup, and
press Q.
4
Select Auto Setup, and then press
select On.
IP Address Setup
Auto Setup
IP Address
Subnet Mask
Default Gateway
Note:
Other items will be greyed out when Auto Setup is set
to On.
Manual Setup:
1
From the PREFERENCES menu, select Network
Setup and press Q.
2
Press or to select Advanced Network
Setup, and press Q.
3
Press or to select IP Address Setup, and
press Q.
4
Select Auto Setup, and then press
select Off .
5
Press or to select IP Address.
6
Press or to select the fi eld you want to
change, and then use the Number buttons to
input the IP address. To save the setting, press
Q.
or to
On
or to
41