Licensing Information - Shure ULX
Wireless Microphone System User Manual

PROBLEM
ULXS4 ULX4P
Sound level from the
receiver is different
from that of a cabled
guitar or microphone.
Sound level is different
when you change
guitars.
Distortion increases
gradually.
Bursts of noise,
distortion, or other radio
signals interrupt
performance.
Momentary loss of
sound as transmitter is
moved around
performing area
(dropouts).
Receiver or Transmitter
LCD displays E000 or
F000 or similar code
instead of the group
and channel.

LICENSING INFORMATION

Changes or modifications not expressly approved by Shure Incorporated could void your authority to operate the equipment.
Licensing of Shure wireless microphone equipment is the user's responsibility, and licensability depends on the user's classifica-
tion and application, and on the selected frequency. Shure strongly urges the user to contact the appropriate telecommunications
authority concerning proper licensing, and before choosing and ordering frequencies.
IMPORTANT!
NOTE: THIS EQUIPMENT MAY BE CAPABLE OF OPERATING ON SOME FREQUENCIES NOT AUTHORIZED IN
YOUR REGION. PLEASE CONTACT YOUR NATIONAL AUTHORITY TO OBTAIN INFORMATION ON AUTHORIZED
FREQUENCIES FOR WIRELESS MICROPHONE PRODUCTS IN YOUR REGION.
Frequency Range of ULX Series: 554 MHz–865 MHz
Licensing: A ministerial license may be required to operate this equipment in certain areas. Consult your national authority
for possible requirements.
INDICATOR STATUS
RECEIVER
TRANSMITTER
ULX1 ULX2
Adjust transmitter gain as necessary.
Adjust receiver volume as necessary.
Adjust transmitter gain to compensate for differences
between guitar output levels.
Replace transmitter battery.
If noise occurs when transmitter is turned off, locate and
remove nearby RF sources, such as other wireless systems,
CB radios, etc.
Change the wireless systems' operating frequency.
Reposition receiver and perform walk-through test. If audio
dropouts persist, mark "dead" spots and avoid them during
performance.
Receiver or transmitter is in Master List mode.
the Master List, press and hold the SET button for approximately
10 seconds or until the display changes.
26
SOLUTIONS
To enter or exit