Shure ULX-D Quick Start Instructions
Digital wireless microphone system
Hide thumbs
Also See for ULX-D:
- User manual (119 pages) ,
- Manual (63 pages) ,
- Quick start instructions (30 pages)
Related Manuals for Shure ULX-D
Summary of Contents for Shure ULX-D
- Page 1 ULX-D ULX-D Digital Wireless Microphone System ©2013 Shure Incorporated 27A16234 (Rev. 2)
-
Page 2: Important Safety Instructions
IMPORTANT SAFETY INSTRUCTIONS 14. REFER all servicing to qualified service personnel. Servicing is required when the ap- paratus has been damaged in any way, such as power supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been READ these instructions. -
Page 3: General Description
A breakthrough in wireless audio quality, Shure digital processing enables ULX-D to deliver the purest reproduction of source material ever available in a wireless system. Extended 20 Hz – 20 KHz frequency range and totally flat response captures every detail with clarity, presence, and incredibly accurate low- end and transient response. -
Page 4: Quick Start Instructions
45° ULXD4 ULXD4 EXIT ENTER ULXD4 Digital Wireless Receiver ENTER www.shure.com Digital Wireless Receiver EXIT EXIT line 15V 0.6A 150 mA 150 mA antenna . B power mic / line inst / aux antenna . A... -
Page 5: Front Panel
Sends IR signal to the transmitter for sync ③ Network Icon ⑩ RF Signal Strength LEDs Illuminates when the receiver is connected with other Shure devices on Indicate the RF signal strength from the transmitter: the network. IP Address must be valid to enable networked control •... -
Page 6: Advanced Transmitter Features
▼▲ eter values ⑧ ⑧ ⑦ Battery Compartment Requires Shure SB900 rechargeable battery or 2 AA batteries. ⑧ AA Battery Adapter ⑩ • Handheld: rotate and store in the battery compartment to use a Shure SB900 battery • Bodypack: remove to accommodate a Shure SB900 battery ⑪... -
Page 7: Home Screens
④ Battery Runtime Indicator The following information cycles when a transmitter is tuned to the receiver's frequency: • Shure SB900 battery: runtime is displayed in hours:minutes remaining • Transmitter Type • AA Batteries: runtime is displayed with a 5-bar indicator •... -
Page 8: Shure Sb900 Rechargeable Battery
Batteries The transmitter runs on two AA batteries or the Shure SB900 rechargeable battery. Use the included AA battery adapter when using batteries other than the Shure SB900. 95A15842 Handheld: Rotate and store the ULXD2 adapter in battery door when... -
Page 9: Scan And Sync
ENTER Multiple System Setup A setup using networked receivers is the fastest and easiest way to distribute the best open channel to each system. See Networking ULX-D Receivers for networking details. Note: Networked receivers must all be within the same frequency band. - Page 10 Setting Receiver Gain The receiver gain control sets the audio signal level for the entire receiver and transmitter system. Changes to the gain settings occur in realtime allowing for adjustments during live performances. When adjusting the gain, monitor the audio meter levels to prevent signal overloads. Receiver Gain Controls Reading the Audio Meter The gain can be adjusted by using the...
-
Page 11: Networking Receivers
Connecting to an External Control System The ULX-D receiver is compatible with external control systems such as AMX or Crestron via the Ethernet, using on the same cables used to carry Shure Control (WWB6). Use only one controller per system to avoid messaging conflicts. -
Page 12: Interference Detection
Best Practices for High Density Mode • When band planning, position ULX-D High Density channels in a range of frequencies separated from other devices. • Use a separate RF zone for ULX-D High Density channels to prevent intermodulation distortion from other devices. -
Page 13: Locking Controls And Settings
Encryption AES algorithm used in Shure ULX-D™ Wireless has been validated (validation no: 2552) by the National Institute of Standards and Technology (NIST) as conforming to the Advanced Encryption Standard (AES) Algorithm, as specified in Federal Information Processing Standard (FIPS) Publication 197, Advanced Encryption Standard. - Page 14 Adding a computer running Wireless Workbench 6 to the network allows for remote control and monitoring of the receiver. ® Visit: www.shure.com/wwb to download Wireless Workbench 6 software. Managing and Monitoring Receiver Settings Manage and monitor receiver settings by opening the Monitor tab in Wireless Workbench.
-
Page 15: Troubleshooting
Troubleshooting Issue See Solution... No Sound Power, Cables, or RF Faint sound or distortion Gain Lack of range, unwanted noise bursts, or dropouts Cannot turn transmitter off or change frequency settings, or can't program Interface locks receiver Encryption error message Encryption Mismatch Power Compatibility... -
Page 16: Ulxd Specifications
ULXD Specifications RF Carrier Frequency Range Audio Dynamic Range 470–937.5 MHz, varies by region (See Frequency Range and Output System Gain @ +10 >120 dB, A-weighted, typical Power table) Total Harmonic Distortion Working Range −12 dBFS input, System Gain @ +10 100 m (330 ft) <0.1% Note: Actual range depends on RF signal absorption, reflection and interference. -
Page 17: Audio Input
0 to 21 dB (in 3 dB steps) 0 to 21 dB (in 3 dB steps) Battery Type Battery Type Shure SB900 Rechargeable Li-Ion or LR6 AA batteries 1.5 V Shure SB900 Rechargeable Li-Ion or LR6 AA batteries 1.5 V Battery Runtime Battery Runtime... -
Page 18: Ta4M Connector
Tables and Diagrams TA4M Connector 500 Ω 500 Ω 5 V DC 100 µF 1µF Ground Audio Input Bias Voltage 12dB 910k Ω 440 pF Audio Input Active Active Load Load Ground µF µF instrument/ aux instrument/ aux µF µF Ω... -
Page 19: Furnished Accessories
RPW184 95AF9279 95F9043 (Blue) KSM9HS RPW186 95M9279 95F9043 (Blue) 95M9279 95M9279 Optional Accessories Shure Rechargeable Battery SB900 UHF Powered Directional Antenna UA874WB 8-Bay Battery Charger SBC800 Passive Directional Antenna PA805SWB Dual Docking Battery Charger SBC200 Coaxial Cable, BNC-BNC, RG58C/U type, 50 Ohm, 2 UA802 ft length (0.6 m) -
Page 20: Important Product Information
Licensing: A ministerial license to operate this equipment may be required in certain areas. Consult your national authority for possible requirements. Changes or modifications not expressly approved by Shure Incorporated could void your authority to operate the equipment. Licensing of Shure wireless mi- crophone equipment is the user’s responsibility, and licensability depends on the user’s classification and application, and on the selected frequency. - Page 21 FREQUENCIES FOR EUROPEAN COUNTRIES ULXD-P51 710 - 782 MHz, max. 20 mW ULXD-G51 470 - 534 MHz, max. 20 mW Country Code Frequency Range Country Code Frequency Range Code de Pays Gamme de frequences Code de Pays Gamme de frequences Codice di paese Gamme di frequenza Codice di paese...
- Page 22 Europe, Middle East, Africa: Shure Europe GmbH Jakob-Dieffenbacher-Str. 12, 75031 Eppingen, Germany Phone: 49-7262-92490 Fax: 49-7262-9249114 Email: info@shure.de PT. GOSHEN SWARA INDONESIA Kompleks Harco Mangga Dua Blok L No. 35 Jakarta Pusat I.16.GSI31.00501.0211...