Receiver Mounting; Rack Mounting A Ulxp4 Professional Receiver; Table Mounting The Ulxs4 Standard Receiver - Shure ULX
Wireless Microphone System User Manual

RECEIVER INSTALLATION

Table Mounting the ULXS4 Standard Receiver

To mount a ULXS4 Standard receiver on a table or other horizontal surface, attach the four adhesive bumpers to the bottom
corners of the receiver and place the receiver on the mounting surface. See Figure 47.
NOTE: The ULXS4 can also be rack mounted, using one of the Rack Mount Kits listed on page 24.

Rack Mounting a ULXP4 Professional Receiver

1. Align the supplied rack-mount brackets over the holes on each side of the receiver, as shown in Figure 48.
2. Fasten the brackets to the receiver by installing the eight screws supplied with the mounting brackets.
CAUTION: Do not overtighten the screws. Doing so may damage the printed circuit boards.
3. Slide the receiver into an 19-inch audio equipment rack
4. Secure the rack-mount brackets to the rack using the four supplied screws.
5. If you are not front mounting the antennas, insert the plastic plugs into the bracket holes.
NOTE: Front–mounting the antennas requires the UA600 Front Mount Antena Kit listed on page 24.
Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ
Ñ Ñ Ñ
FIGURE 48
Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ
Ñ
Ñ Ñ
FIGURE 49
FIGURE 50
19
1/4 IN.
Ñ Ñ Ñ
Ñ Ñ Ñ Ñ
Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ
Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ
.
, as shown in Figure 49