Preparing The Handset; Inserting The Battery Into The Handset - Siemens Hicom cordless EM Gigaset 3000 Micro Operating Instructions Manual

Preparing the handset

Inserting the battery into the handset

Note:
Please read the safety notes on page 2 first!
Only use the permitted battery, do not use any other
batteries or normal batteries (non-rechargeable) – see
page 12.
Proceed as follows to insert the battery:
Fig. 2 Inserting the battery
Hold the handset with the dialling keypad facing down-
wards. A battery compartment for the battery is located
in the lower part of the handset.
To open the battery compartment, press the grooves and
slide the lid downwards in the direction of the arrow. Lift
off the lid.
Insert the battery connector into the jack with the small
tabs facing upwards and left as shown.
Insert the battery into the battery compartment with the
label facing upward. Ensure that the cable is not trapped
under the battery.
Position the lid at a distance of a few millimetres from
the battery compartment. Slide the lid of the battery com-
partment upwards until it slots into place.
11