Preparing To Use Your Phone; Preparing To Use The Handset - Siemens IL TELEFONO ALESSI User Manual

Preparing to use your phone

Preparing to use your phone
The pack contains:
one IL TELEFONO ALESSI handset, a charger, two batteries, a power supply unit with
power cord, one set of operating instructions.

Preparing to use the handset

The display is protected by a plastic film. Remove the protective plastic film!
Inserting the batteries
1. To open the battery compartment, press down on the battery cover as shown and
slide the cover down – see figure on left.
2. Insert the batteries ensuring correct polarity – see centre figure.
3. To close the battery compartment, position the cover so that it is open by about
3 mm then slide up until it closes with a click – see figure on right.
Use only the rechargeable batteries recommended on page 25! Never use
conventional batteries (non-rechargeable) or other battery types as this
W
may cause significant damage to health and property. For example, the
jacket of the battery could be destroyed (hazardous). The phone could
also malfunction or be damaged.
Placing the handset into the base (registering) and charging the batteries
When you place the IL TELEFONO ALESSI handset into the base, it will register to the
base automatically. Proceed step by step as follows:
1. Place the handset vertically in the base with the display to the front.
2. Wait till the handset has registered automatically to the base: This operation takes
around one minute. While registration is in progress the screen displays
Regstr.Procedure and Base 1 flashes. When the handset has registered, the
internal number that is assigned to it appears in the display (e.g. "INT 2").
3. Now leave the handset in the charger for the batteries to charge – the batteries are
supplied uncharged. Battery charging is indicated in the top right of the display by
the flashing battery icon
6
=
.