Right-Side Components; Removing Right-Side Components - KYMCO MXU400 Service Manual

Right-Side Components

AT THIS POINT
To service center crankcase components only, pro-
ceed to Removing Right-Side Components.
NOTE: For efficiency, it is preferable to remove
and disassemble only those components which
need to be addressed and to service only those
components. The technician should use discretion
and sound judgment.
AT THIS POINT
To service any one specific component, only limited
disassembly of components may be necessary. Note
the AT THIS POINT information in each sub-section.
NOTE: The engine/transmission does not have to
be removed from the frame for this procedure.
Removing Right-Side
Components
A. V-Belt Cover
B. Driven Pulley
C. Clutch Cover
1. If the engine is still in the frame, remove the cap
screw securing the brake pedal to the pivot shaft.
Account for a flat washer.
2. Remove the cap screws securing the V-belt cover
to the clutch cover; then slide the brake pedal out-
ward and remove the V-belt cover. Account for
two alignment pins and a gasket.
3. Mark the movable drive face and the fixed drive
face for installing purposes; then remove the nut
holding the movable drive face onto the crank-
shaft.
4. Remove the movable drive face and spacer.
Account for the movable drive face rollers and
outer drive face cover.
KC149A
KC142A
3
MD1033
MD1035
3-29