Axminster AWMS10 User Manual page 15

Identification & Description of the Mitre Saw...
Dust extraction A 48mm (2")dust extraction outlet extruded from the top guard that
port allows the saw to be connected to a suitable extraction system. If dust
extraction is not available, a sawdust collecting bag is supplied for
'quick' jobs.
Support rails 10mm steel bar bent into a 'U' section. The saddle of the 'U' is further
bent to be above the line of the arms. The arms are introduced into the
two holes in the side of the main chassis, they should then be pushed
home into the locating and stabilising bracket. When correctly located
the upstand of the 'U' section is at the same height as the machine table.
Clamp in position using the star handled clamp bolt.
Work piece Comprising a threaded block atop a mounting spigot, with a threaded
clamps length of bar through it. The threaded bar has a turning handle on one
end and a limited swivel pressure plate on the other. There is also a
spring plate to facilitate a 'clip' action when the clamp is mounted on the
saw chassis.
Illustration & Parts Description...
45˚
degrees
Angle scale
Tilt adjustment stop
Tilt and pivot assembly
Tilt angle Tilt clamping
pointer
Laser
W
A X M I N S T E R
W H I T E
knob
15