Advertisement
When unpacking, check the unit for signs of shipping damage (damaged box, scratches,
dents, etc). If there is any damage to the unit or it fails to meet specifications, notify
your localt sales representative immediately. .
This IEEE-488 interface card has two DIP switch (SW1 and SW2), 1 one slide switch
(SW3) and three jumpers (JP1, JP2 and JP3). The: setting must be coincident with the
application program.
4
PCL-848AB
Legend:
CN1: GP-IB connector CN2: Digital output
connector
SW1: I/O port base address and wait states
SW2: Firmware base address SW3: Operation
mode (PCL-748 or NI PCÑI I )
JP1: DACK channel JP2: DRQ channel JP3:
IRQ level Fig. 2.2 . Location of switches and
jumpers
Fig. 2.2 Location of switches and jumpers
User's Manual
Advertisement
