Table of Contents
Advertisement
Fig. 4 Conduit Openings,
Enclosure Mounting,
and Dimensions
6. Mounting
LowProfile can be mounted in a variety of methods. The basic method is to wall mount using the mounting feet attached
to the base of the enclosure. LowProfile can also be mounted even (or flush-mount) to the exterior wall surface. Mount
LowProfile using construction methods and hardware appropriate for your site. Install the conduit hub, chase nipple and
pull conductors as specified above or according to the engineer's design. See Figure 3 for enclosure and mounting
dimensions.
7. Optional Flush-Mount Plate
Optional flush-mount plate, part number LP-FMP, can be purchased for flush-mount installation. Typically a cutout, larger
than the LowProfile enclosure, is created in the drywall or other finish material. See Figure 4 for the recommended cutout
gap (dimensions L1 and L2). Use the flush-mount plate to hide the gap between the enclosure and the cutout edges. Prior
to installation, attach the plate to the enclosure using the existing cover screws.
™
LOWPROFILE
InstaLLatIOn, OPERatIOn and MaIntEnancE ManuaL
5
Advertisement
Table of Contents
