Hotpoint RGB744GER Use And Care & Installation page 40

CONVERTING SURFACE BURNERS ON
MODELS EQUIPPED WITH SEALED BURNERS (See
Step 4ifrange isequippedwith dual burners.)
l. Removegrates, burner caps and burner heads.
2. Remove burner bases by unscrewing the 3
small screws in each base. Lift
straight out.
disconnect the wires from the burner
bases unless the cooktop needs to be raised.
3. Remove the brass orifice spud under each
burner base by unscrewing spud from fitting with
7mm or 5/16" wrench (depending on the size of
your spuds).
Apply a 3/4" wrench to the hex
on the gas inlet tube as a back-up when
removing spud to prevent the aluminum
tube from twisting.
Install orifice spuds accordin to one of the
4.
following diagrams (see
converting to.
40
INSTALLATION INSTRUCTIONS
burner
or
B ), for LP
Orifice Spuds for Converting to 1P Gas:
LP orifice spuds are in a small plastic bag packed
with this Use and Care book. LP orifice spuds
have a 2-digit number and the Letter "L" on
one side. Each orifice spud will also have 1 or 2
grooves on one side, denoting the location on
the range where it is to be installed.
Orifice Spuds for Converting to Natural Gas:
spuds have a 3-digit number
Natural gas orifice
on one sicle. Each orifice spud will also have 1, 2
or 3 grooves on one sicle, denoting the location
on the range where it is to be installed.