Table of Contents
Advertisement
Cord will be Discomected Infrequently.
Power
An adapter maybe used only on a 15-amp
circuit. Do not use an adapter on a 20-amp
circuit. Where local codes permit, a
TEMPORARY CONNECTION
made to a properly grounded two-prong wall
available at most hardware stores. The larger
slot in the adapter must be aligned with the
proper polarity in the connection of the
power cord.
TEMPORARY METHOD
(ADAPTER PLUGS NOT
PERMITTED IN CANADA)
ALIGN LARGE
PRONGS/SLOTS
Attaching the adapter ground
CAUTION:
terminal to the wall receptacle cover screw
does not ground the appliance unless the cover
screw is metal, and not insulated, and the wall
receptacle is grounded through the house
wiring. The customer should have the circuit
checked by a qualified electrician to make sure
the receptacle is properly grounded.
When disconnecting the power cord from the
If this is not done, the adapter ground terminal
is very likely to break with repeated use. Should
this happen,
DO NOT USE
proper ground has again been established.
may be
.
'
/
ENSURE PROPER
GROUND AND
FIRM CONNECTION
BEFORE USE
the appliance until a
Situations where Appliance
Cord will be Disconnected Frequently.
not use an adapter plug in these situations
because disconnecting of the power cord
places undue strain on the adapter and leads to
eventual failure of the adapter ground terminal.
The customer should have the two-prong
wall receptacle replaced with a three-prong
(grounding) receptacle by a qualified electrician
before using the appliance.
The installation of appliances designed for
mobile home installation must conform with
the Manufactured Home Construction and
Safety Standard, Title 24 CFR, Part 3280
(formerly the Federal Standard for Mobile
Home Construction and Safety, Title 24, HUD,
Part 280) or, when such standard is not
applicable, the Standard for Manufactured
Home Installations, latest edition (Manufactured
Home Sites, Communities and Set-Ups), ANSI
Canada, mobile home installation must be in
accordance with the current CAN/CSA
Electric Disconnect
1. Locate disconnect plug on the range back.
2. Pinch sides of connector and pull out of
range back.
You will have one of these disconnect
plugs.
Power
35
Advertisement
Table of Contents
