Connecting The Speakers - JVC RX-8030VBK Instructions Manual

A
A
N N
T E
A N
7 5
F M IA L
A X
C O
ANTENNA
AM
Extend the supplied FM antenna
EXT
horizontally.
AM
LOOP
FM 75
Outdoor FM Antenna Cable
COAXIAL
(not supplied)
Note:
If reception is poor, connect the outdoor FM antenna (not supplied).
Before attaching a 75 Ω coaxial cable with a standard type connector
(IEC or DIN 45325), disconnect the supplied FM antenna.
AM Antenna Connections
ANTENNA
AM
EXT
AM
AM Loop Antenna
LOOP
(supplied)
Snap the tabs on the loop into the slots
of the base to assemble the AM loop.
FM 75
COAXIAL
1 2
Outdoor single vinyl-covered wire (not supplied)
Notes:
• If the AM loop antenna wire is covered with vinyl, remove
the vinyl by twisting it as illustrated.
• Make sure the antenna conductors do not touch any
other terminals, connecting cords and power cord. This
could cause poor reception.
• If reception is poor, connect an outdoor single vinyl-covered wire
(not supplied) to the AM EXT terminal. (Keep the AM loop antenna
connected.)
8
B
A
N N
T E
A N
7 5
F M IA L
A X
C O
FM Antenna (supplied)
Turn the loop until you have the
best reception.
3

Connecting the Speakers

You can connect the following speakers:
• Two pairs of front speakers to produce normal stereo sound.
• One pair of surround speakers to enjoy the surround effect.
• One surround back speaker or one pair of surround back speakers
to enjoy to produce more effective surround effect.
• One center speaker to emphasize human voices.
• One subwoofer to enhance the bass.
CAUTION:
Use only the speakers of the SPEAKER IMPEDANCE indicated by
the speaker terminals.
• When connecting to both of the FRONT SPEAKERS 1 and 2
terminals, use speakers with an impedance of 16 Ω to 32 Ω.
• When connecting to either the FRONT SPEAKERS 1 or 2
terminals, use speakers with an impedance of 8 Ω to 16 Ω.
Basic connecting procedure
1 Twist and remove the insulation at the end of
each speaker signal cable (not supplied).
2 Open the speaker terminal.
3 Insert the speaker signal cable.
4 Close the speaker terminal.
1 2
For each speaker (except for a subwoofer), connect the (+) and
(–) terminals on the rear panel to the (+) and (–) terminals
marked on the speakers.
Speaker layout
Ideal speaker layout varies depending on the conditions of your
listening room. The diagram below is a recommended typical
example.
Left front speaker(s) Center speaker
(L) (C)
Left surround
speaker (LS)
Surround back speakers (LSB/RSB)
3 4
Subwoofer
Right front speaker(s)
(R)
Right surround
speaker (RS)