One-Touch Raid Configuration - HIKVISION DS-9608NI-ST Quick Operation Manual

Quick Operation Guide of Network Video Recorder
1) Click the Custom Adding button to pop up the Add IP Camera (Custom) interface.
2) You can edit the IP address, protocol, management port, and other information of the IP camera to be
added.
3) Click Add to add the camera.
4) (For the encoders with multiple channels only) check the
as shown in the following figure, and click OK to finish adding.

One-touch RAID Configuration

Purpose:
For the DS-9600NI-RT/XT series NVR, the disk array must be configured if you want to save recording and log
files locally. Through one-touch configuration, you can quickly create the disk array. By default, the array type to
be created is RAID 5.
Before you start:
As the default array type is RAID 5, at least 3 HDDs must be installed in you device.
Steps:
1. (For DS-9600NI-XT series only) Enable the RAID function by checking the checkbox in the disk mode
configuration interface.
Menu > HDD > Advanced
2. Enter the Physical Disk Settings interface.
Menu > HDD > RAID
of Channel No. in the pop-up window,
checkbox
36