Recording - HIKVISION DS-9608NI-ST Quick Operation Manual

Quick Operation Guide of Network Video Recorder
Interface Introduction
No. Name
1 Channel List
Live View Window
2
Play Control Bar
3
PTZ Control
4
Video Parameters
5
Configuration
Start Live View
Steps:
1. In the live view window, select a playing window by clicking the mouse.
2. Double click a camera from the device list to start the live view.
3. You can click the
Refer to the following table for the description of buttons on the live view window:
Icon Description
Select the window-division mode
Start/Stop all live view
/
Capture pictures in the live view
mode
Start/Stop all recording
/
Previous/Next page
/

Recording

Before you start
Make sure the device is connected with HDD or network disk, and the HDD or network disk has been initialized
for the first time to use.
Two recording types can be configured: Manual and Scheduled. The following section introduces the
configuration of scheduled recording.
Steps:
1. Click Remote Configuration> Camera Settings> Record Schedule to enter Record Schedule settings
interface.
2. Select the camera to configure the record schedule.
Description
Displays the list of channels and the playing and recording status of each
channel.
The stream type can be switched by clicking the icon before the channel name:
stands for main stream and
Displays the image of channel, and multi-window division is supported.
Play control operations are supported.
Pan, tilt, zoom operations are supported, as well as preset and patrol editing
and calling.
PTZ function can only be realized if the connected camera supports PTZ control.
Brightness, contrast, saturation and hue of the image can be edited.
button on the toolbar to start the live view of all cameras on the device list.
for sub-stream.
Icon Description
Open/Close audio
/
Start/Stop two-way Audio
/
Adjust volume
Enable/Disable digital zoom
/
Full screen
29