Table of Contents
Advertisement
Subnet Mask
Gateway IP
Metric
4. Click Apply .
5. To delete a route, select the entry in the static/default route table and click Delete .
To configure static ARP
The ARP table maps an IP address to a device's MAC address.
1. In the left panel, click Forwarding .
2. In the top panel under IP Forwarding, click Static ARP .
3. Click New and configure these fields.
Interface Name
IP Address field
MAC Address
4. Click Apply .
5. To delete a route, select the entry in the static ARP table and click Delete .
IP Address Filtering
You can manually configure the switch to drop packets from specified MAC and IP addresses. For
information about specifying MAC addresses to drop, see the Forwarding | Unicast MAC
Address Setting screen.
To specify an IP address for filtering
1. In the left panel, click IP Address Filtering .
2. Click New and configure these fields.
IP Address
Intel® NetStructure™ ZT 8101 10/100 Ethernet Switch User's Manual
Field
Specifies the corresponding subnet mask for the IP address.
Specifies the address of the next hop gateway for the IP address. This is
usually a router with a connection to a WAN or the Internet.
Specifies the Routing Information Protocol (RIP) metric. This is the number
of hops between the IP address and the gateway. This is a number between
1—15.
Field
Specifies the IP interface of the IP address that you are adding to the static
ARP table.
Specifies the IP address of the end node or station.
Specifies the MAC address corresponding to the IP address.
Field
Specifies the IP address of the packets you want dropped.
Using the Web Console
Description
Description
Description
117
Advertisement
Table of Contents
