Kenmore 4908 series Owner's Manual And Installation Instructions page 11

1. Drape the power cord over the washer top.
2. Move the washer to its final location.
3. Place the drain hose in the laundry tub or standpipe as
shown. See illustrations A and B.
A B C
4. If the washer faucets and the drain standpipe are recessed,
put the hooked end of the drain hose in the standpipe as
shown. See illustration C.
NOTES:
[] Do not force excess drain hose back into the rear of the
washer.
[] To avoid siphoning, do not seal the drain hose into the
standpipe.
Level your washer by turning the leveling legs in or out as
necessary by hand or the wrench included with your washer.
When your washer is level, tighten the nuts using the wrench or
(-) driver.
NOTES
[]
Your Washer must be leveled on all four sides. A carpenter's
level should be used on all four corners of your Washer. It's
a good idea after the first dozen washes to recheck your
washer's levelness.
1. Check the electrical requirements. Be sure that you have the
correct electrical supply and the recommended grounding
method. See "Electrical Requirements."
2. Check that all parts are now installed. If there is an extra part,
go back through the steps to see which step was skipped.
3. Check that you have all of your tools.
4. Dispose of or recycle all packaging materials.
5. Check that the water faucets are on.
6. Check for leaks around faucets and inlet hoses.
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
7. Plug into a grounded 3 prong outlet.
8. Read "Washer Use."
9.
To test and to clean your washer, using only "HE" High
Efficiency detergent, measure 1/2 the amount of detergent
recommended by the manufacture for a medium size load.
Pour the detergent into the detergent dispenser. Select
NORMAL/CASUAL, and then select START. Allow the washer
to complete one whole cycle.
[] To avoid damage to the legs, do not move the Washer unless
the Lockingnuts are fastened to the bottom of the Washer.
Use only HE High Efficiency detergent.
11