How To Use Accessory Tray; How To Use Spray Tips - Troy-Bilt 2,700 PSI Operator's Manual

NOTICE Spray gun traps high water pressure, even when
engine is stopped and water is disconnected.

How to Use Accessory Tray

The unit is equipped with an accessory tray with places to
store your spray gun, nozzle extension, high pressure hose
and quick connect spray tips.
1. Place spray gun through notches on left side of
accessory tray as shown.
2. Place nozzle extension in hole on left side of accessory
tray as shown.
3. Insert multi–colored spray tips in spaces provided in
accessory tray.
4. Hang high pressure hose on hook attached to the right
side of the accessory tray as shown.

How to Use Spray Tips

The quick–connect on the nozzle extension allows you to
switch between four different quick connect spray tips. Spray
tips can be changed while pressure washer is running once
spray gun trigger lock is engaged. The spray tips vary the
spray pattern as shown.
Follow these instructions to change spray tips:
1. Pull back collar on quick–connect and pull current
spray tip off. Store spray tips in holder provided on the
accessory tray.
WARNING The high pressure stream of water that
this equipment produces can cut through skin
and its underlying tissues, leading to serious
injury and possible amputation.
• NEVER exchange spray tips without the trigger locked on the
spray gun.
• DO NOT twist spray tips while spraying.
2. Select desired spray tip:
High Pressure
40° White 15° Yellow
• For delicate rinse, for gentle cleaning of cars/trucks,
boats, RV's, patio furniture, lawn equipment, etc.,
select white 40° spray tip.
• For general rinsing, ideal for most all purpose
cleaning such as home siding, brick patios, wood
decks, driveways and sidewalks, garage floors, etc.,
select yellow 15° spray tip.
• For maximum rinsing, for stubborn or hard to reach
surface such as second story surfaces, paint
removal, oil stains, rust removal or other stubborn
substances (tar, gum, grease, wax, etc.), select red
0° spray tip.
• To apply detergent, applies project specific cleaners
to help break down stubborn dirt and grime on a
variety of surfaces, select black detergent spray tip.
3. Pull back on collar, insert new spray tip and release
collar. Tug on spray tip to make sure it is securely in
place.
Usage Tips
• For most effective cleaning, keep spray tip from 8 to
24 inches (20 to 61 cm) away from cleaning surface.
• If you get spray tip too close, especially using a high
pressure spray tip, you may damage surface being
cleaned.
• DO NOT get closer than 6 inches (15 cm) when
cleaning tires.
Low Pressure
Magenta
Use to apply
detergent
0° Red
13