Table of Contents
Advertisement
PRODUCT SPECIFICATIONS
• This appliance has been certified for
use with either natural or propane
gas. See appropriate data plates.
• This appliance is not for use with
solid fuels.
• The appliance is approved for bed-
room or bedsitting room installa-
tions.
• The appliance must be installed in
accordance with local codes if any. If
none exist use the current installation
code. ANSI Z223.1/NFPA 54 in the
USA, CSA B149 in Canada.
• This appliance is mobile home
approved.
• The appliance must be properly con-
nected to a venting system.
• The appliance is not approved for
closet or recessed installations.
WARNING
Do not remove
insulation board.
Figure 1 - 500DVH Fireplace
(Millivolt Unit Shown -
Also Available in Electronic
Ignition and Remote Hi/Lo with
Blower Models)
CODE APPROVAL
Direct Vent type appliances draw all combustion air from outside of the dwelling through the vent pipe.
These appliances have been tested by CSA and found to comply with the established standards for DIRECT VENT GAS
FIREPLACE HEATERS in the USA and Canada as follows:
A manufactured home (USA only) or mobile home OEM installation must conform with the Manufactured Home Con-
struction and Safety Standard, Title 24 CFR, Part 3280, or when such a standard is not applicable, the Standard for
Manufactured Home Installations, ANSI/NCSBCS A225.1, or Standard for Gas Equipped Recreational Vehicles and
Mobile Housing, CSA Z240.4.
56D3049
Hi/Lo Knob
Off/Pilot/On Knob
On/Off/RS Switch
LISTED VENTED GAS FIREPLACE HEATER
TESTED TO: ANSI Z21.88b-2008/CSA 2.33b-2008 STANDARDS
PRODUCT FEATURES
Insulation
Board
Ignitor
Blower Control
Optional Remote
Receiver
CODE APPROVAL
and
Hood
Nailing
Flange
1
/
" Nailing
Flange
1
/
"
5
/
"
8
Nailing
Flange
5
Advertisement
Table of Contents
