Table of Contents
Advertisement
OPERATING INSTRUCTIONS - REMOTE HI/LO WITH BLOWER
3-SPEED BLOWER CONTROL - See Figure 72
1. Press FAN button once to enter blower speed setup mode at low speed initially and
one of the three blade icon will display darken on LCD display.
2. Continue to press FAN button to set up the blower speed you desire.
3. If there is no input within 3 seconds, the new setting will be transmitted to receiver.
If fireplace is on, the blower speed will take effect right away; if fireplace is off, the
receiver will remember this setting and blower is still off.
4. If you continue to press FAN button to the position that all blade is gone, the FAN
icon will disappear and turn the blower off.
BLOWER ON DELAY TIME AND OFF DELAY TIME SETTING
See Figure 73
1. Hold FAN button for 5 second and two numbers will show up in LCD screen. The
upper one is On Delay Time and the bottom is Off Delay Time.
2. Use the ON/▲ button to set the desired On Delay Time from 0 to 15 min.
3. Use the OFF/▲ button to set the desired Off Delay Time from 0 to 15 min.
4. If there is no input within 3 seconds, the new setting will be transmitted to receiver.
5. The default settings for both transmitter and receiver are 5 minutes for On Delay Time
and 8 minutes for Off Delay Time, as shown in this picture.
NOTE: The most efficient setting for your fireplace blower is when blower
comes on and off and it is blowing warm air only not hot air, giving the
fireplace enough time to discharge as much warm air as possible before
turning off.
FLAME HEIGHT SETTING FOR THERMOSTATIC MODE
See Figure 74
1. Hold AUTO/FLAME button for 5 seconds and a number and flame icon will show
up on the LCD screen, as show in the right figure.
2. Use the ON /▲ or OFF / ▲ button to set the desired flame height to 1 (Min), 2 (Medium)
and 3 (Max).
3. If there is no input within 3 seconds, the new setting will be transmitted to receiver.
This setting only affects auto mode operation.
4. The default setting for transmitter is 2 (Medium), as shown in right picture.
LOW BATTERY DETECTION - See Figure 75
1. Battery voltage is checked once a minute. When the battery voltage drops to a cer-
tain level, the low-battery icon will display on LCD, and the transmitter will turn
off the appliance. The transmitter will not function anymore until fresh batteries are
installed.
2. When the batteries are low, the LCD displays a low battery indicator. The low battery
indicator will be displayed in any mode.
3. The transmitter will not operate with low batteries. Change the batteries before the
batteries are too weak for normal operation. TURN THE UNIT OFF BEFORE
REPLACING BATTERIES.
48
-
Time and Off Delay
-
70
° F
Figure 72 -
3-Speed Blower
Mode
05
08
F
°
Figure 73 -
Blower On Delay
Time
02
Figure 74 -
Flame Height
Setting
70
° F
Figure 75 -
Low Battery
Detection
Continued
56D3049
Advertisement
Table of Contents
