Yeti Cycles SB66 2013 Owner's Manual page 12

assembly
13.
install the shock onto the frame. insert a 34 mm
ti female bolt with a shock bolt washer through
the drive side of the frame and shock. Use a ti
male bolt prepped with blue loctite on the non-
drive side and tighten with two 5mm allen keys.
15.
Grease the upper link pivot axle and install it
through the swingarm and the upper link bearings
from the drive side of the frame. Use a dead blow
hammer to tap the pin into place.
24.
14.
repeat the process for the shock and upper link
interface. Use the fox guide pin tool and a dead
blow hammer to help guide any female ti bolts
through the frame and frame components.
torque both bolts to 90-95 in/lb.
16.
apply blue loctite to the threads on an axle link
cap. install and tighten into the upper link pivot
axle with two 6mm allen keys.
torque to 90-95 in/lb.
17.
apply blue loctite to four m6x1x20 socket head
cap bolts and install and tighten the pinch bolts
into the swingarm with a 5mm allen key.
torque to 90-95 in/lb.
assembly
18.
Double check the alignment of all frame
components and torque settings on all assembly
hardware.
25.