Advertisement
Available languages
Available languages
TROUBLESHOOTIHG,
(ONT.
ice maker is not
producing ice
AND WATER,
com.
Ice makerarm is not incorrectposition
Householdwater supply is not reaching
water vaIve
Copper or plastictubing has kinks
Water pressure is too low
Check freezer temperature
ice bin is not installed properly
improper watervalvewas installed
Confirm ice maker arm is down See Freezer Features
.........
sect!0nin your owner's manual for details
Check water connection procedure written in Installing Your
Refrigerator.
Turnoff water suppiy and remove kinks ttkinks cannot be
rem°ved._..[ep!ace tubing
Water pressure mustbe between 20 to100 poundsper square
inchto function properly A minimumpressureof 35 pounds per
square inch is recommendedfor refrigerators withwater filters
Seetemperature controls section in Installing Your
Refrigeratorto adjust your controls. Freezer must be
between0 to 2+ F (-18 to -17 ° C) !o produce ice.
See ice bin section for proper installation and alignment.
Check water connection procedure in your Installation
Instructions
Self*piercing and _'m" s addle valves causelow
water pressure and may clog the line over time The
manufacturer is nat responsible for property damage due
Waterfiller needs to be replaced
Filterindicatorsensor needs to be reset.
Plastictubingwas usedto complete water
connection
.........................
to improper installation or water connection,
Waterfilter indicator light
If fiiter is not available, replace withbypass filter See
is red
Dispenser Featuressection for directions.
See Dispenser Features section for directions.
Refrigerator is leaking
The manufacturer recommendsusing copper tubingfor
water
installation.Plastic is less durable and can cause leakage
The manufacturer is not responsible for property damage
..... due.to .!mproper installation or water connection.
.......................
improper water valve was +nstafled
Check water connection procedure in yourInstallation
Instructions
Self-piercing and _,_"saddle valves cause low
water pressure and may dog the line over time The
manufacturer is not responsiblefor property damage due
to improper installationor water connection.
Waterpressure is low.
Water pressure must be between 20 to 100 pounds per
Allow approximately12 hoursfor water in holding tank to chili
Discard first glass of waier and refill
ice forms in inlet tube
to ice maker
Water flow is slower
than normal
Freezertemperatureis too high,
Water pressure is too low
improperwatervalve was installed
Copperor plastictubinghas kinks.
Waterfitter is clogged or needs to be
changed:
Befrigera!or has been recent!Yinsta!led,
_
Water supply in holding tank has been
depleted.
Water has settledinto water lines outside
holding tankand has warmed to room
temperature.
.........
Dispenser water is not
cold
square inch to function properly A minimumpressure of 35
poundsper square inch is recommended for refrigerators with
water filters.
See temperature controls section in installing Your
Refrigeratorto adjust your controls. Freezer must be
between 0 to 2° F (-18 to -17". C) to produce ice+
Water pressure must be between20 to 100 pounds per
square inchto function properly.A minimum pressure of 35
poundsper squareinchis recommended for refrigerators with
water filters.
Check water connection procedure in your installation
Instructions. Self-piercing and _A_" saddle valves causelow
water pressure and may clog the line over time The
manufactureris not responsible for property damagedue
..... to !mproper..!nsta!!ation or water connection...
Turnoff watersupply and remove kinks if kinks cannot be
removed,re lace tubin.
Change water filter
Advertisement
