Download Print this page

Kenmore 596.526732 Use And Care Manual page 17

Side-by-side refrigerator
Hide thumbs Also See for 596.526732:

Advertisement

Available languages

Available languages

fiiEEZEll
FE UflES
AUTOMATIC
ICE M AKEfl
To avoid property damage, observe
the following:
:_ Be NOT force ice maker arm
down or up....
>- 00 NOT place or store anything in
ice storage bin,
This ice maker creates the ice used in
the dispensing system.
Using Ice Maker for the First Time
> Confirm ice bin is in
_------------_._
place and ice maker
arm is down
> After freezer section reaches
between 0° to 2°F (-t8 ° to -17oC),
ice maker filfs with water and begins
operating,
> Allow approximately 24 hours after
installationto receive first harvest of
ice°
>- Discard ice created withinfirst 12
hours ofoperation to verify system is
flushedof impurities.
Operating Instructions
>- Confirm ice bin is in place and ice
maker arm is down.
> After freezer section reaches 0° to
2°F (-18° to -17° C), ice maker fills
with water and begins operating. You
will have a complete harvest of ice
approximatelyevery 3 hours
> Stop iceproduction
by raising ice maker
arm until click is
heard.
> Ice maker will remain inthe off
position until arm ispusheddown.
IMPORTANT: Ice Cream Sheff should
not be instafledif ice maker arm is in
"off" position
SHELVES
FREEZER SHELF
To remove and install
_4t_
A
clip-mounted
shelves:
> Toremove, pull shelf from wall
mountingclips and pull [eft side of
shelf out of walt mounting holes
>. Toinstall,placeshelf in mountinghole
and attach to wall mountingc?ips.
To remove and Jnsta?l rail-mounted
shelves:
> To remove,snap
right side of shelf
from cabinet railing
and remove from wall mounting clips
To install, replaceshelf in wall
mountingclips Be sure back edge of
shelf is flush with back of cabinet and
snap shelf into cabinet railing
ICE CREAM SHELF
provides a space for
itemsto be chilled or -
frozen quickly
Toremove, lift ice cream shelf from
icebin rails and pull straight out.
_ Toinstall,fit shelf over top of ice
maker and lower onto ice bucket rails.
IMPORTANT: Ice Cream Shelf should
not be installed if ice maker arm is in
"off"position.
To avoid possible injury, including
death, do not pIace glass items in ice
cream shelf.
Glass objects may
shatter or explode if exposed to
extreme cold.
FREEZER BASKET
'Toremove and install
basket"
__
=nil n=_ll nnt In it_ fitll _t__n,_inn
Lift up front of basket and remove
> To install,slide basketinto railsat
bottomof freezer section.. L ift up front
of basket,and slideto the back of
refrigerator
ICE STORAGE BIN
The Ice Storage
Bin is located below
the automatic
dispensing ice
maker_
To remove and install ice storage bin:
;-- To remove bin, remove ice cream
shelf.
Raise ice maker arm to deactivate ice
maker Lift front of bin and pull outto
its full extension. Lift up front of bin
andremove
>- To install,slide bin intorails below ice
maker until bin locks intoplace. Drop
ice maker arm to activate ice maker,
and replace ice cream shelf.
IMPORTANT: Ice bin must be locked in
proper place lot
r'_
_
proper ice
dispensing If
freezer door
does not close, bin isnot in proper
location.Turn auger driver
counterclockwise(as shown) to properly
align ice bin with back of refrigerator.
ADJUSTABLE DOOR
BUCKETS
Door Buckets adjustto meet individual
storage needs,
To remove buckets:
>- Lift the door bucket up until
it clears the retainers on the
door liner, then pull the
door
bucket
straightout.
To reinstall buckets:
> Slide bucket in above desired door
liner retainer and push down until
bucket stops.
!'11
Z
r"
m
Z
17

Advertisement

loading