Panasonic KX-MB2100 series Operating Instructions Manual page 87

Feature Code
ECM selection #413
Connecting tone #416
Maximum fax #418
speed
Quick scan mode #419
Confirming the #420
destination
Dial keypad entry #421
restriction
Fax number #422
re-entry
Dial tone detection #423
Confirming the #424
next document
Activating the #430
Distinctive Ring
feature
Setting the ring #431
pattern for fax
(Distinctive Ring
feature)
Description
To set the Error Correction Mode (ECM). This feature is available
when the sending / receiving fax machines are ECM compatible.
When this feature is activated, fax transmission / reception will be
carried out so that the errors do not occur.
If you often have trouble when sending faxes, activating this feature
allows you to hear connecting tones: fax tone, ring back tone and busy
tone. You can use these tones to confirm the status of the other
party's machine.
Note:
R If the ring back tone continues, the other party's machine may not
be a fax machine or may have run out of paper. Check with the
other party.
R The connecting tone cannot be adjusted individually.
To set the maximum fax speed (14.4 kbps/33.6 kbps). The fax speed
may be lower than the selected speed depending on your line.
To enable quick scan mode. When this feature is activated, the unit
will scan the document and store it into memory first, then the unit will
start sending the documents.
To confirm the destination before sending a fax. When it is activated,
you can send a fax after confirming the destination. When the
displayed destination is correct, press Mx/STARTN to send the fax.
If you want to restrict dialling fax numbers manually using the dial
keypad (to avoid misdialling, for example), activate this feature.
Note:
R When this feature is activated,
– you cannot make redial calls to fax numbers entered using the
dial keypad.
– the fax number re-entry setting (feature #422) will be
deactivated.
When this feature is activated, if you dial a fax number manually using
the dial keypad, you have to re-enter the number and press Mx/
STARTN. When the 2nd entry number matches the 1st entry number,
you can send the fax.
When this feature is activated, a dial tone of sending faxes is detected
to check if the line is connected before starting transmission. If a dial
tone is not detected, the unit enters redial standby.
When this feature is activated, after the document is scanned using
the automatic document feeder during fax memory transmission, the
message shows to confirm the next document. Insert the next
document and press MOK/SETN. A Mx/STARTN
To activate the Distinctive Ring feature. See page 100 for details.
To set the ring pattern for fax (Distinctive Ring feature). See
page 101 for details.
– "A": Standard ring (one long ring)
– "B": Double ring (two short rings)
– "C": Triple ring (short-long-short rings)
– "D": Other triple ring (short-short-long rings)
– "B-D": The fax will respond to all calls with ring tone patterns
"B", "C", and "D".
8. Fax
Default
key
M1N
M1N
M2N
M0N
M0N
M0N
M0N
M1N
M0N
M0N
M5N
87