Panasonic KX-MB2100 series Operating Instructions Manual page 58

6. Scanning
5
If necessary, change the scanning settings.
MEN A MCDN: Select the desired setting. A MOK/SETN
6
When using the scanner glass:
Mx/STARTN A The unit will scan 1 page. Place the next document on the scanner glass and press MOK/SETN.
Repeat this until all the documents are scanned, then press Mx/STARTN.
When using the automatic document feeder (y):
Mx/STARTN
7
After you finish scanning, press Mw/STOPN to reset the setting you set in these procedures.
Available formats for scan image save
Scanning mode
*1
"VIEWER"
*1
"FILE"
*1
"EMAIL"
*1
"OCR"
"EMAIL
*2*3
ADDRESS"
*2*3
"FTP SERVER"
*2*3
"SMB FOLDER"
*1 When scanning several pages and saving as a single file, select TIFF or PDF as the file format.
*2 When scanning several pages and saving as a single file, select PDF as the file format.
If TIFF is selected as the file format, we recommend using the Multi-Function Viewer/Quick Image Navigator to
display the scanned image.
*3 LAN connection only. (y)
How the scanned data is handled
The scanned image will be automatically saved in the folder selected in the [Settings] window of Multi-Function
Station. To change the folder, see page 36.
R When scanning to Quick Image Navigator (for JT models), the scanned image will be displayed in the [Quick
Image Navigator] window after scanning.
When scanning to Multi-Function Viewer (for models other than JT models), the scanned image will be
displayed in the [Multi-Function Viewer] window after scanning. However, when you select PDF as a file format,
the software that is associated to open PDF files will start.
R When scanning to email, the email software will automatically start and the scanned image will be attached to
a new email message.
R When scanning to OCR, the scanned image will be displayed in the OCR window after scanning.
R When scanning to email address, the scanned image will be sent as an email attachment directly from this unit.
R When scanning to FTP server, the scanned image will be automatically saved in the selected folder on the FTP
server.
To display the scanned image, download the data to your computer beforehand.
R When scanning to SMB folder, the scanned image will be automatically saved in the selected folder on the
network.
When scanning to SMB folder does not perform properly, consult your network administrator. This unit's SMB
function does not support NTLMv2 and SMB signatures.
Activating scan to email address (LAN supported models only) (y)
1. Register the email destinations. See page 49 for details.
R You can also enter the destination email address directly in step 4 on page 57.
2. Program the email server settings.
1. Start Multi-Function Station.
2. [Device] A [Configuration Web Page] A [Network]
58
TIFF JPEG
U U
U U
U U
U U
U U
U U
U U
BMP PDF
U U
U U
― U
U ―
― U
― U
― U