Table of Contents
Advertisement
Fire risk
Safety precautions while servicing
E 2007 Nordson Corporation
With lamps running at up to 800 degrees Centigrade, there is always a risk
of fire should any paper or materials get jammed under or in the lamp
vicinity, or in the event of build-up of fluff, dirt or powder within the lamp
housing.
Should such a situation occur, the operator must:
WARNING: Switch off the equipment immediately. If a fire extinguisher is
to be used, make sure it is of a type which is suitable for use with electrical
equipment.
A suitable fire extinguisher should be available near the unit.
This equipment is fitted with high temperature lamps. It is not designed to
operate close to low flash point materials (solvents, etc.).
Important Information
All electrical maintenance and servicing must be carried out by a qualified
engineer. It is preferable to call in Nordson UV for this servicing facility.
WARNING: This equipment operates at high voltage and is therefore
potentially dangerous. All precautions must be taken by the qualified
engineer in servicing this equipment. The equipment must be isolated at
the mains before opening any of the access covers.
In the event of your qualified engineer being unable to find fault with the
equipment, then Nordson UV Service should be called in.
Control System Cleaning
It is essential that all contactors and relays are kept clean and free from dirt
and dust ingression. These should be checked regularly, particularly in
extremely dusty or powder-charged working rooms.
MiniCure 08-07
1-9
Safety
Part 7119745C
Advertisement
Table of Contents
