Setting Surface Controls; General Cooktop Information - Kenmore 790.9911. Use & Care Manual

Kenmore range user manual
Table of Contents

Advertisement

Setting Surface Controls
FEATURE OVERVIEW
General Cooktop Information
About Radiant Surface Burners
Locations of the Radiant Surface Elements and Controls
About
the Ceramic
Glass Cooktop
The ceramic cooktop has radiant surface elements located below the surface of
the glass. The design of the ceramic cooktop outlines the area of the surface
element underneath (See Figs. 1 & 2).
Heat is transferred
up through the surface of the cooktop to the cookware. The
type and size and condition of the cookware, the number of surface elements in
use and their settings, are all factors that will affect the amount of heat that will
spread to areas beyond the surface elements.
Note: The areas surrounding
the elements may become hot enough to cause burns.
About the Radiant Surface
Elements
The element temperature
rises gradually and evenly. As the temperature
rises,
the element will glow red. To maintain the selected setting, the element will
cycle on and off. The heating element retains enough heat to )rovide a uniform
and consistent heat during the off cycle. For efficient cooking, turn off the
element several minutes before cooking is complete. This will allow any
remaining heat to complete the cooking process.
Fig. 1
NOTE: Radiant elements have a tmiter that allows the element to cycle on and off, even at the HI setting. This helps to
_'_
prevent damage to the ceramic smoothtop. Cycling at the HI setting is normal and can occur if the cookware is too
F'_
small for the radiant element or if the pan bottom is not flat. Refer to page 13 for more details about using proper
cookware on the cooktop.
Locations
of the Radiant
Surface
Elements
and
Controls
Your range is equipped with radiant
surface burners the have eight
different wattage ratings. The
ability to heat food quicker and in
larger volumes increases as the
element wattage increases.
The radiant surface elements are
located on the cooktop as follows
(refer to Fig. 3); a 6 inch radiant
element located at the right rear
position; a 6 / 9 / 12 inch Triple
radiant element located at the right
front position (See page 10); a
Warmer Zone radiant element at
the center rear position (See page
12); and two 8 inch radiant
elements located at both the left
front and rear positions. Located
between the left front and rear
elements is a Bridge radiant
element (See page 11).
NOTE: Be sure to read detailed
instructions
for ceramic glass
cooktop cleaning in the General
Care & Cleaning
section and
Before You Call checklist section
of this manual.
AU._|
_i! ¸ A
] HI
÷BRI_E_
_
FnONT_0
_
LO
SlZE_
=iiiiiii!Iiiiiiiiii_=
SiZE

Advertisement

Table of Contents
loading

Table of Contents