Before Setting Surface Controls - Kenmore 790.7443 Series Use & Care Manual

Before Setting Surface Controls

Check burner cap placement before operating the
surface burners
To prevent flare-ups and avoid creation of
harmful by-products, do not use the cooktop without all burner
caps properly installed to insure proper ignition and gas flame
size.
On round style burners, the burner cap lip (See Fig. 1) should fit
snug into the center of burner head and rest level. Refer to Figs.
2 & 3 for correct and incorrect burner cap placement. Once in
place, you may check the fit by gently sliding the burner cap
from side to side (Fig. 4) to be sure it is centered and firmly
seated. When the burner cap lip makes contact inside the
center of the burner head you will be able to hear the burner
cap click. Please note that the burner cap should NOT move off
the center of the burner head when sliding from side to side.
Check and be sure that all oval style (some models) burner caps
are correctly in place on oval burner heads.
It is very important to be sure that all surface burner caps and
burner grates are properly installed and in the correct locations
BEFORE operating the cooktop burners.
Remember:
• Always keep surface burner caps in place whenever using a
surface burner.
• When placing the burner caps, be sure that all burner caps
are seated firmly and rest level on top of burner heads.
• For proper flow of gas and ignition of burners DO NOT
allow spills, food, cleaning agents or any other material
to enter the gas orifice port opening.
Installing burner grates
Do not use the surface burners without the
burner caps and burner grates properly installed. Missing pieces
or improper installation may lead to spills, burns, or damage to
your range and cookware.
Make sure the burner grates are properly placed on the cooktop
before using the surface burners. The grates are designed to rest
inside the recess on the cooktop.
To install burner grates, place grates flat-side down and align
into the cooktop recess. Grates should rest flush against each
other and against the sides of the recess.
Burner head
Figure 3: Burner cap on burner head
Correct burner cap
placement
Figure 4: Correct placement (L) Incorrect placement (R)
Figure 5: Moving cap gently until seated properly
Figure 6: How to place burner grates properly
12
Burner cap
Burner cap lip
Incorrect burner cap
placement