Table of Contents
Advertisement
Placement
of Burner
Caps
and
Trim
Rings
and
Grates
Place grate over burner pans. Make sure that the groove under grate fits over the raised
lip of the burner pan.
The rounded corners of the grates should be placed toward the
front of the range for the front burners and toward the rear of the range for the back
burners.
Grate
Surface
Cooking
FEATURE OVERVIEW
Positioning Burner
Grates
•
Setting Surface
Controls
lip pan
Setting Surface Controls
Your range may be equipped
with any combination
of the following
burners:
Simmer Burner,
this burner is best used for simmering
delicate sauces, etc.
Standard Burner, can be used for most all surface cooking needs.
Large Burner, the larger burner is best used when bringing large quantities of liquid to
temperature
and when preparing larger quantities
of food.
Regardless of size, always select a utensil that is suitable for the amount and type of
food being prepared.
Select a burner and flame size appropriate
to the pan. Never allow
flames to extend beyond the outer edge of the pan.
Each burner lights automatically
from an electric ignitor each time a control knob is
turned to the LITE position.
_1_
Do not place plastic items such as salt and pepper
shakers, spoon
holders or plastic wrappings
on top of the range when
it is in use. These items could
melt or ignite. Potholders, towels or wood spoons could catch fire if placed too close to
a flame.
To
operate
the
surface
burner:
1.
Place cooking utensil on burner.
2.
Push the Surface Control knob in and turn counterclockwise
out of the OFF
position.
3.
Release the knob and rotate to the LITE position. Note: All four electronic
ignitors
will click at the same time. However, only the burner you are turning on will ignite.
3.
Visually check that the burner has lit.
4.
Push the control knob in and turn counterclockwise
to the desired flame size. The
control
knobs do not have to be set at a particular
mark. Use the guides and adjust
the flame as needed.
DO NOT cook with the Surface Control
knob in the LITE
position.
(The electronic
ignitor
will continue
to click if left in the LITE position.)
rl1
Z
r--
m
:3:
In the event of an electrical
power outage,
the surface burners
can be lit manually. To
light a surface
burner,
hold a lit match to the burner
head, then slowly turn the Surface
Control
knob to LITE. After burner
lights push in and turn knob to desired setting.
Use
caution
when
lighting
surface
burners
manually.
13
Advertisement
Table of Contents
