Linking And Unlinking The Remote Keyless Entry Transmitter To Memory; Memory Position Recall - Jeep Cherokee 2014 Owner's Manual

• For vehicles equipped with a manual
transmission, the vehicle speed must be
at 0 mph (0 km/h) to recall a memory
profile.
• The Recall Memory with Remote Key Un-
lock feature can be turned on and off
through the EVIC, if equipped. If the Re-
call Memory with Remote Key Unlock is
not turned on
Programmable Features then the Linking
and Unlinking the Remote Keyless Entry
Transmitter to Memory will not be suc-
cessful. Refer to "Electronic Vehicle Infor-
mation Center
Programmable
"Understanding Your Instrument Panel"
for further information.
Linking And Unlinking The Remote
Keyless Entry Transmitter To
Memory
Your Remote Keyless Entry (RKE) transmitters
can be programmed to recall one of two pre-
programmed memory profiles with a press of
the UNLOCK button on the RKE transmitter.
86
PAGE POSITION: 88 JOB: @zeta.tweddle.com/InfoShareAuthoroChrysler/CLS_InfoShareAuthoroChrysler/GRP_Owners_Manual/JOB_1461427-en-2014_CHEROKEE_EE+14KL-126-ENG-AA/DIV_Owners_Manual_v2
NOTE:
Before programming your RKE transmitters
you must select the "Memory To FOB" fea-
ture through the Uconnect® system screen.
Refer to "Customer- Programmable Fea-
tures — Uconnect® Access 8.4 Settings " in
"Understanding Your Instrument Panel" for
further information.
in (EVIC)/Customer-
To program your RKE transmitters, perform the
following:
1. Remove the key from the ignition.
2. Select the desired memory profile 1 or 2.
(EVIC)/Customer-
3. Press and release the SET button on the
Features" in
memory switch, then within five seconds press
and release the side of the rocker switch la-
beled 1 or 2 accordingly. "Memory Profile Set"
(1 or 2) will display in the EVIC, if equipped.
4. Press and release the LOCK button on the
RKE transmitter within 10 seconds.
NOTE:
Your RKE transmitters can be unlinked to
the memory setting by pressing the SET
button followed by the UNLOCK button on
the RKE transmitter in Step 4 above.

Memory Position Recall

NOTE:
• For vehicles equipped with an automatic
transmission, the vehicle must be in
PARK to recall memory positions. If a
recall is attempted when the vehicle is not
in PARK, a message will display in the
EVIC, if equipped.
• For vehicles equipped with a manual
transmission, the vehicle speed must be
at 0 mph (0 km/h) to recall memory posi-
tions. If a recall is attempted with the
vehicle speed above 0 mph (0 km/h), a
message will display in the EVIC, if
equipped.
To recall the memory settings for driver one,
press MEMORY button number 1 or the UN-
LOCK button on the RKE transmitter linked to
memory position 1.
To recall the memory setting for driver two,
press MEMORY button number 2 or the UN-
LOCK button on the RKE transmitter linked to
memory position 2.