Jeep Cherokee 2014 Owner's Manual page 290

6. Using a ballpoint pen or similar object, press
and hold the recessed power transfer unit NEU-
TRAL (N) button (located by the selector switch)
for one second.
Neutral Switch
7. When the NEUTRAL (N) indicator light turns
off, release the NEUTRAL (N) button.
8. After the NEUTRAL (N) button has been
released, the power transfer unit will shift to the
position indicated by the selector switch.
288
PAGE POSITION: 290 JOB: @zeta.tweddle.com/InfoShareAuthoroChrysler/CLS_InfoShareAuthoroChrysler/GRP_Owners_Manual/JOB_1461427-en-2014_CHEROKEE_EE+14KL-126-ENG-AA/DIV_Owners_Manual_v2
NOTE:
When shifting the power transfer unit out of
NEUTRAL (N), turning the engine OFF may
be required to avoid gear clash.
9. Shift the transmission into PARK.
10. Release the brake pedal.
11. Disconnect vehicle from the tow vehicle.
12. Start the engine.
13. Press and hold the brake pedal.
14. Release the parking brake.
15. Shift the transmission into DRIVE, release
the brake pedal, and check that the vehicle
operates normally.
NOTE:
• Steps 1 through 5 are requirements that
must be met prior to pressing the NEUTRAL
(N) button, and must continue to be met
until the shift has been completed. If any of
these requirements are not met prior to
pressing the NEUTRAL (N) button or are no
longer met during the shift, the NEUTRAL
(N) indicator light will flash continuously
until all requirements are met or until the
NEUTRAL (N) button is released.
• The ignition switch must be in the ON/
RUN position for a shift to take place and
for the position indicator lights to be op-
erable. If the ignition switch is not in the
ON/RUN position, the shift will not take
place and no position indicator lights will
be on or flashing.
• A flashing NEUTRAL (N) position indica-
tor light indicates that shift requirements
have not been met.