Viking VCBB360R Service Manual page 49

ICEMAKER
Ejector Blades or Stripper
1 Remove module and support assembly
2 Install ejector blades, realigning "D" coupling
with module cam.
Accessing Control Box
1. Remove motor and contact assembly from
control box by removing 3 screws.
2. Remove shut-off arm
3. Pull free.
Caution:
To avoid main assembly damage do not
rotate blades of drive gear.
Switches will jam if turned counterclockwise and
gears will be destroyed if turned clockwise. Advance
icemaker into cycle be using a jumper to bridge H
and R. Icemaker will not run if motor is defective.
Shut-off arm must be in on position.
several slotted shafts on motor assembly board. Do
not insert screwdriver and attempt to turn shafts.
Slots permit assembly only. There are non-repairable
and non-replaceable components in module. When
diagnosing or repairing icemaker, do not remove
module unless replacing module.
Water Fill Adjustment
Turning water level adjustment screw will move
contact in relationship with contact ring segment.
This causes contact to vary time water valve is
energized. Contact ring is tapered at end of fill time.
There are
•
Turning screw clockwise decreases fill time.
•
Turning screw counterclockwise increases fill
time
•
½ turn equals 20 cc or 1.2 seconds.
•
Full turn equals 40 cc or 2.4 seconds.
49