Disassembly Procedures - Viking VCBB360R Service Manual

Disassembly Procedures

Door Components
Air Discharge Grille
1. Remove center vane.
NOTE: During reassembly replace vane with
curve up, curved/notches end first.
2. Remove 4 screws.
3. Pull grille assembly forward.
Refrigerator Door
To avoid personal injury or
property damage, two people
are required for door removal.
1. Remove grille.
2. Turn power switch off.
3. Remove glide pin screw (torx #15M) from
underside of top door hinge pin plate.
4. Loosen four 3/8" bolts enough to raise upper
hinge plate to clear door hinge pin.
5. Lift door off of center hinge plate.
6. Remove door.
Freezer Drawer and Basket
Pull forward
Door Stops
1. Remove air discharge grille.
2. Remove two #15 torx screws.
Door Handles
1. Pry off screw trim. New trim will be required
for reassembly.
2. Remove 6 screws on freezer door and 9 screws
on refrigerator door, using a Phillips screwdriver.
Door Gaskets
1. Gently pull gasket away from door liner.
2. Reinstall be beginning in bottom corner, working
up. Align raised portion of gasket into liner
track and apply pressure.
Inner Door Liner and Outer Door Shell
Replace complete door assembly.
Refrigerator Door Switch
1. Remove air discharge grille.
2. Remove two #1 point Phillips screws with an
offset ratchet tool.
Cabinet Components
Refrigerator Fan
1. Remove air grille caps.
2. Remove air grille by removing four ¼" hex head
screws.
3. Disconnect leads
4. Remove fan by removing ¼" hex head screws.
Refrigerator Light Switch
An offset or ratchet #1 point Phillips driver is
required
1. Remove air discharge grille.
2. Remove 2 Phillips screws securing switch to top
door hinge.
Refrigerator Light Socket
1. Remove cover by removing four ¼" hex head
shoulder screws and sliding cover to rear.
2. Remove bulbs.
3. Remove four ¼" hex head screws on light socket
housing. Uncap front and drop down.
4. Pry socket through housing.
5. Remove wiring.
Center Mullion
Center mullion is not replaceable.
Service Mullion Heater
Heater is connected by servicer to spare wire in
harness. See Component Testing for connection
procedures. Heater is not replaceable.
Freezer Switches and Thermistor Panel
1. Remove screw retaining assembly to evaporator
cover.
2. Remove leads.
3. Pry switch assemblies from cover.
4. Remove thermistor by removing 2 screws
Freezer Evaporator Cover
1. Remove freezer shelf, freezer basket, ice service
rack, icemaker, switch, and thermistor mounting
plate.
2. Remove four ¼" hex head evaporator cover
mounting screws.
3. Push icemaker electrical block through opening
in panel. Remove panel.
Defrost Thermostat
1. Uncap thermostat from outlet on evaporator coil.
2. Disconnect orange and brown leads.
Evaporator Defrost Heater
1. Complete steps 1 – 3 of evaporator coil removal.
2. Tip bottom of evaporator coil out.
3. Remove 2 clips.
4. Slide heater down and out from coil.
5. Unplug heater leads.
Important: When reassembling, verify air diverter
strips have been reinstalled properly.
44