Sw & Factory Reset; Configuration & Operation - opticis IPKVM-310-ED User Manual

You can decide the authority on the 3-state slide switch of IPKVM-310E (Transmitter) among
Local, Remote, or Console. If it set to Console on the 3-state slide switch, you can set the
authority state to Local or Remote on the external console switch. And you can see same
status via LEDs on the Console switch and Console Indicator. (Refer to "A.1 Externally
Setting Local/Remote Authority")
 SW & Factory Reset
♦ SW Reset: Press the Reset switch on the back of devices shortly to reset the default software.
♦ Factory Reset: To recover the Factory setting, press and hold the Reset switch on the
Back of devices until the LED is turned off after blinking approx.10sec.
 Configuration & Operation
Note: Please keep the installation procedure below. Improper or no operation may result if the start-up
sequence is not followed correctly.
Important: IPKVM-310ED supports static fixed IP on the network and a default IP is 192.168.0.100 on
the Txs and 192.168.0.200 on the Rxs. And also, Gateway is 192.168.0.1 and Subnet Mask is
255.255.255.0 in both Txs and Rxs. So you need change the IP address to another one ,which you
want, by using PC Program.
- 12 -